/ 01
Setpoint optimisation
Cooling setpoints tuned continuously inside comfort limits.
PRODUCT_03Autonomous Energy AI
WattGrid
An autonomous energy operator for buildings.
In Development
WattGrid is an autonomous energy optimisation layer for buildings. It works with the control systems already installed to tune cooling setpoints, chiller sequencing, peak shaving and pre-cooling — targeting meaningful kWh reduction without replacing capital equipment.
// the problem
The problem it solves.
In the Gulf, cooling is the largest single line in most building energy bills, and the equipment producing it usually runs on schedules and setpoints that were fixed years ago.
Tuning it properly is a continuous job — weather, occupancy and load change hourly, and no operator can hold that loop open all day across every zone and chiller.
The usual alternative is a capital project. WattGrid is designed to work with the plant already installed, inside comfort and safety limits set by the operator, with any efficiency figure treated as a target to be verified — not a result already achieved.
// how it works
How it works.
/ 01
Connect to the plant
A non-invasive link to the existing building control system over open protocols.
/ 02
Learn the building
Load, weather, occupancy and local patterns are observed before anything is changed.
/ 03
Recommend, then act
Adjustments start as recommendations and move to supervised control at the operator's pace.
/ 04
Verify the savings
Consumption is measured against a baseline so every target is checked, not assumed.
// capabilities
Key capabilities.
/ 02
Chiller sequencing
Plant staged to match load instead of a fixed schedule.
/ 03
Peak shaving
Demand peaks flattened around the hours that cost the most.
/ 04
Pre-cooling
Cooling shifted ahead of expected load where the building allows it.
/ 05
Operator guardrails
Hard comfort and safety limits, with override available at any time.
/ 06
Measurement and verification
Results reported against a baseline; targets are labelled as targets.
// audience
Who it's for.
Commercial buildings
Offices and retail where cooling dominates the electricity bill.
Facilities teams
Operators who want tighter control without a capital replacement project.
Multi-site portfolios
Owners comparing performance across several buildings on one baseline.
// next
Interested in WattGrid?
We're working with a small number of partners as we build. Tell us about your operation and we'll reply within 24 hours.